pegasus-rs

Multiplatform drivers for pegasus equipment written in Rust.

This driver is meant to communicate with all pegasus powerboxes on all major platforms.

Run locally (UNIX/Windows)

Be sure to have rust installed (if you don't have rust check here and simply run on your terminal/cmdshell cargo run

Build a debug version of the program (UNIX/Windows)

in your terminal type cargo build

Build an optimized version of the program AKA the version that will run for real (UNIX/Windows)

in your terminal type cargo build --release

Pegasus PPBA protocol instructions

Command	Description	Response
P#	Status	PPBA_OK
PE:bbbb	Set Power Status on boot. Every number represents 1-4 power outputs. (0=OFF, 1=ON).	PE:1
P2:nn	ON/OFF Power 8V DSLR (0=OFF, 1=ON) n can also accept values of: 3, 5, 8, 9, 12 (Volts)	P2:nn
P3:nnn	PWM Duty Cycle Power 5 (DewA) X=0-255 (0-100%)	P3:nnn
P4:nnn	PWM Duty Cycle Power 6 (DewB) X=0-255 (0-100%)	P4:nnn
PF	Reboot Device / Reload Firmware	[none]
PA	Print Power and Sensor Readings	[Check table below]
PS	Prints Power Consumption Statistics	PS:averageAmps:ampHours:wattHours:uptime_in_millisec
PC	Print Power Metrics	*Current is represented in Amps and does not require conversion. PC:total_current:current_12V_outputs: current_dewA:current_dewB:uptime_in_ millisec
PR	Prints discovered I2C devices plugged to EXT port	PR:HDC:DHT:XS if there is a discovered device command will output its name HDC = temp/humidity sensor TI HDC1050 DHT =stock temp/humidity sensor AM2301 XS: eXternal Motor (stepper) Controller
DA	(Auto) Dew Aggressiveness from 0 to 255 (210 default value)	DA:nnn
PD:b	Enable/Disable Auto Dew Feature (X=0,1) PD:99 Reports Auto Dew Aggressiveness value	PD:nnn
PV	Firmware Version	n.n
PI	Reset I2C channel	PI:1
PL:b	OF/OFF Led Indicator (0=OFF, 1=ON)	PL:b