lowlevel_lpf/2024.1-1

This release contains the low pass filter demo for the Eclypse Z7. Make sure to download the Eclypse-Z7-Low-Level-Low-Pass-Filter-hw.xpr.zip release archive, rather than the source archives.

Check out the demo page on Digilent Reference for more information.

OOB/2024.1-1

To use this release, download the "-hw.xpr.zip" and "-sw.ide.zip" files, then follow instructions found in this README to set up the demo and run it on your board.

This release is associated with the oob/master branch of this repository.

Prerelease - Streaming Data to DDR using Scatter Gather DMA

To use this release, download the -hw.xpr.zip and -sw.ide.zip files and follow instructions found at this page on Digilent Reference.

Eclypse Z7 Low Level Lowpass Filter Demo Vivado 2023.1

This release contains the low pass filter demo for the Eclypse Z7. Make sure to download the Eclypse-Z7-Low-Level-Low-Pass-Filter-hw.xpr.zip release archive, rather than the source archives.

Check out the demo page on Digilent Reference for more information.

Prerelease - Streaming Data to DDR using Scatter Gather DMA

To use this release, download the -hw.xpr.zip and -sw.ide.zip files and follow instructions found at this page on Digilent Reference.

Eclypse Z7 Low Level Lowpass Filter Demo Vivado 2019.1

This release contains the low pass filter demo for the Eclypse Z7. Make sure to download the Eclypse-Z7-Low-Level-Low-Pass-Filter-hw.xpr.zip release archive, rather than the source archives.

Check out the demo page on Digilent Reference for more information.

Eclypse Z7 Low Level Lowpass Filter Demo Vivado 2019.1

This release contains the low pass filter demo for the Eclypse Z7. Make sure to download the Eclypse-Z7-Low-Level-Low-Pass-Filter-hw.xpr.zip release archive, rather than the source archives.

Check out the demo page on Digilent Reference for more information.

v0.3

Unzip the image then use dd to write to an SD card

with a card reader over usb

# dd if=/path/to/extracted/image/eclypse-debian-buster-armhf-rfs.img of=/dev/(sdX or mmcblkX}  && sync

On first boot the board rootfs partition will resize to fill the SD card then reboot.

user: eclypse
password: eclypse

Update:

The main difference between v0.3 and v0.2 is an update to decutil (currently v1.5.0)

v0.2

Unzip the image then use dd to write to an SD card

with a card reader over usb

# dd if=/path/to/extracted/image/eclypse-debian-buster-armhf-rfs.img of=/dev/(sdX or mmcblkX}  && sync

On first boot the board rootfs partition will resize to fill the SD card then reboot.

user: eclypse
password: eclypse

Initial image

Unzip the image then use dd to write to an SD card

with a card reader over usb

# dd if=/path/to/extracted/image/eclypse-debian-buster-armhf-rfs.img of=/dev/(sdX or mmcblkX}  && sync

On first boot the board rootfs partition will resize to fill the SD card then reboot.

user: eclypse
password: eclypse